- Hamilton01698 829711
- Leeds0113 235 1356
- Belfast02890 830302
Kewtech KEWEVSE EVSE Adapter
Includes: Kewtech KEWEVSE, Carry Case and Manual.
The Kewtech KEWEVSE is the smallest in class EVSE adapter for testing the functionality and allowing your EV enabled MFT to test the electrical safety parameters of your EV charging point.
TESTING OF THE CHARGING STATION
PE Pre-Test
Prior to all other tests the PE pre-test must be successfully carried out. Never touch PE terminals at the mains socket on the back of the adapter before the PE pre-test is successfully finished.
The PE Pre-test allows the operator to test the PE conductor for the possible presence of dangerous voltage against earth.Normally the PE conductor is connected to earth and has no voltage against earth.In a situation where the PE conductor is not connected to earth (mistakingly connected to phase or possibly broken) the user is exposed to a ‘danger to life’ situation.
Test Procedure:
Connect the test adapter to the charging station.
Touch the touch pad (no. 6) with a bare finger.
If the light indicator (no. 5) is illuminated then a dangerous voltage is present at the PE conductor. Stop further testing immediately and remedy the wiring fault.
Do not wear gloves while performing this test and ensure a proper connection to earth. Never touch any metal parts during this test. In the case of improper earthing (e.g., operators body is isolated from the earth) this test may be not reliable.
FEATURES
Enables electrical safety testing of electric vehicle charging points compatible with any EVSE testing equipment.
4mm connectors and alternative BS1363 socket for connecting your tester.
For testing domestic and commercial EV charging equipment.
CP & PP state adjustment rotary switches.
PE error & CP error simulation test.
Oscilloscope output.
CompactEasy to use.
Input voltage | Max. 250V (single-phase), max. 430V (three-phase) 50/60Hz. |
Measurement Category | CAT II 300V. |
Mains socket rating | 250V/10A. |
Mains socket protection | Fuse T10A/250V. |
PP simulation | Open circuit, 13A, 20A, 32A, 63A. |
CP simulation | States A, B, C, D. |
Error simulation | CP error “E”, PE (earth fault) error. |
PE Pre-Test | Yes. |
Test connector type | IEC62196-2 Type 2 male. |
Test cable length | 25cm. |
Working temperature | 0 … +40ºC. |
Storage temperature | -10 … +50ºC. |
Humidity | 0-80% RH. |
No customer reviews for the moment.